Spongy wall

2018-05-10 17.40.09.jpg

I was in trouble with 3D printing that the contour of the printed body is not a straight line, but from dots, little lines. This is going to be done with finer designs, where it does not, it does it pretty much from the line.
The attached picture shows that the base is fine, but the wall is not good, spongy.
What could be the reason?

Printer: Anet A8

Program: Cure 3.3.1

Thanks for help

2018-05-10 17.40.22.jpg

Published by

3D Printing

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

Leave a Reply

Your email address will not be published. Required fields are marked *