- Voltage: 12v
- Power: 40w
- Material: Stainless Steel
- Diameter: 6mm
- Length: 20mm
(1) 3D Printer Controller RAMPS 1.4
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino-compatible Mega with the powerful Arduino-compatible MEGA platform and has plenty room for expansion. The modular design includes plug in stepper drivers and extruder control electronics on an Arduino-compatible MEGA shield for easy service, part replacement, upgrade-ability and expansion.
for more informations, you can check here : http://www.amazon.com/gp/product/B00JU41GQ4
(2) Mega 2560 R3
for more informations, you can check here : http://www.amazon.com/gp/product/B00E94CGTQ
(3) A4988 Stepper Motor Driver
A4988 is a complete microstepping motor driver with built-in translator for easy operation
for more informations, you can check here : http://www.amazon.com/gp/product/B00JXGT1G6
(4) LCD 12864 Graphic Smart Display Controller
This full graphic Smart Controller contains a SD-Card reader, an rotary encoder and a 128 x 64 dot matrix LCD display. You can easy connect it to your Ramps board using the “smart adapter” included.
for more informations, you can check here : http://www.amazon.com/gp/product/B00L72FAZU
(1) RAMPS 1.4 x 1
(2) Mega 2560 R3 x 1
(3) A4988 Stepper Motor Driver with Heatsink x 5
(4) LCD 12864 Graphic Smart Display Controller x 1
(5) Smart Adapter x 1
(6) 30cm Cable x 2
(7) USB Cable x 1
(8) Storage Box x 1
Here is the firmware for you to use with Ramps 1.4 https://www.dropbox.com/s/56qbizg7l56k2lw/Marlin-Marlin_v1%20for%20lcd%2012864.zip Marlin for ramps 1.4 + A4988 stepper driver + LCD 12864 controller
Each phase draws 2A, allowing for a holding torque of 59Ncm(83.6oz.in). It’s very good choice for 3D printer.
* Manufacturer Part Number: 17HS19-2004S
* Motor Type: Bipolar Stepper
* Step Angle: 1.8 deg.
* Holding Torque: 59Ncm(83.6oz.in)
* Rated Current/phase: 2.0A
* Phase Resistance: 1.4ohms
* Inductance: 3.0mH+/-20%(1KHz)
* Frame Size: 42 x 42mm
* Body Length: 47mm
* Shaft Diameter: 5mm
* Shaft Length: 19.5mm
* D-cut Length: 19.5mm
* Number of Leads: 4
* Lead Length: 225mm
* Weight: 390g
Black(A+), Green(A-), Red(B+), Blue(B-)
Make sure the motor connect to a constant current or chopper drive controller before you test motor.
Connecting the motor directly to a power supply will destroy the motor.
Specifications: Application: makerbot 3D printer extruder Size£:26.5mm*M6 Material:stainless steal Net weight:4g Size of screw: M6 Out size :6mm
Package included: 5PCS * M6 x 26.5 Nozzle Throat for makerbot 3D Printer Extruder Hot End